Dynapac DFP12D, Operating Instruction

Page: 76 / 98

6. Loosen the screw (1) for approx. five turns and pull the oil
filter (2) out of the housing.
7.
CAUTION!
Danger of eye injuries caused by particles
flying around!
– Wear your personal protective equipment
(safety gloves, protective working
clothes, goggles).
Use compressed air to blow the oil filter out from the inside to
the outside.
8. Check the seal ring (2) for damage, change if necessary.
9. Slightly oil the seal rings (1) and (2).
10. Insert the oil filter (2) into the housing and press it against the
end stop.
11. Before tightening the screw (1) make sure that the tensioning
springs touch the oil filter with both ends.
12. Tighten the screw.
Cleaning the oil filter
Fig. 60
Fig. 61
Fig. 62
Maintenance – Annually
DFP12D 76