16
CP 132 M132EN3
EVERY 50 HOURS OF OPERATION (Weekly)
Front suspension – Lubrication
The grease fitting (1) of the steering bearing is located
under suspension rotating flange, there are four (4)
fittings, but use only one.
Lubricate the steering bearing with 3 strokes of the
grease gun.
Front suspension main (2) pin must not rotate.
Check if the lock plate is missing or damage.
Grease the front suspension main pin (2) with 3
strokes of the grease gun.
1
Fig. 19 Steering joint, assembly
1. Steering bearing
2. Front suspension pin
3. Grease fitting
2
3
Front oscillation shaft
– Lubrication
Fig. 20 Oscillating shaft
Wipe all the fittings clean from dirt and grease.
Lubricate each fitting with five strokes of the grease
gun. Make sure that grease enters the pin.
If grease does not enter the pin it may be necessary to
relieve the articulated joint with a jack and repeat the
greasing procedure.
Steering cylinder – Lubrication
Fig. 21 Steering cylinder
Wipe all the fittings clean from dirt and grease.
Lubricate each fitting with two strokes of the grease
gun.
Leave a little grease on the fittings after greasing. This
will prevent dirt from entering the fittings.
CAUTION
Summary of Contents for CP 132
Page 2: ...19 ILF015WO1...
