3
CA121/141 O121EN4
SAFETY INSTRUCTIONS (Also read the safety manual)
1. The operator must be familiar with the contents of the OPERATION
MANUAL before starting the roller.
2. Make sure that all instructions in the MAINTENANCE MANUAL are
followed.
3. Only trained and/or experienced operators may drive the roller.
No passengers are allowed on the roller. Remain seated during all operation.
4. Never use the roller if it is in need of adjustment or repairs.
5. Board and leave the roller only when it is stationary. Use the grips and
railings. A ”three-point grip” is always recommended when boarding or
leaving the machine—either both feet and one hand, or one foot and both
hands in contact with the machine.
6. Always use the Roll Over Protective Structure (ROPS) when the machine
is used on risky ground.
7. Drive slowly in sharp bends.
8. Avoid driving at an angle on slopes; drive straight up or down.
9. When driving close to unsafe edges or holes, make sure that at least two
thirds of the drum width is firmly on material that has already been
compacted.
10. Make sure that there are no obstacles in the direction of travel, on the
ground or overhead.
11. Drive extra carefully on uneven ground.
12. Use the safety equipment provided. The seat belt must be worn on
machines with ROPS.
13. Keep the roller clean. Clean dirt and grease from the operator’s platform
without delay. Keep all signs and decals clean and clearly legible.
14. Safety measures before refueling:
– Stop the engine.
– Don’t smoke.
– No naked flame in the vicinity.
– Ground the nozzle of the filling device against the tank to prevent sparks.
15. Before repairs or service:
– Place chocks against the drum/wheels and against the strike-off blade.
– Lock the articulation if necessary.
16. Hearing protectors are recommended if the noise level is higher than 85
db(A).
The noise level will vary depending on the surface you are working on.
17. Do not make any changes or modifications on the roller that could affect
safety. Changes may only be made with Dynapac’s written consent.
18. Do not use the roller until the hydraulic fluid has reached its normal
working temperature. Braking distance will be longer than usual when the
fluid is cold. See the starting instructions in the OPERATION MANUAL.
Summary of Contents for CA121
Page 2: ...19 ILF015WO1...
