Installation, Operation and Service Manual
LKP Series
© 2016 DynAmp, LLC
Page 31
041738 I
7.4 SPARE PARTS ORDERS - ROUTINE OR EMERGENCY
Requests for spare parts should be directed to "Service" at DynAmp, LLC during normal
hours. When contacting us, please present as much information as possible, such as the
related equipment Model and Serial Numbers (available on the equipment tag); the
required part name; its DynAmp, LLC item number (and other identifying or vendor
number(s); and your time needs. An approved Purchase Order Number should be given
with your order.
7.5 RECOMMENDED SPARE PARTS
The following table lists the minimum recommended quantities* for spare parts for the LKP
Metering Unit. As spares are used, replacements should be ordered. Since continuous
operation of high-current measurement systems is usually critical, stocking spare parts
should be given high priority.
A single module “A” kept on hand (see part number below), can be used to replace either
of the modules in the Metering Unit and guarantee quick, error free repair. Note that a
module “B” cannot be used to replace a module “A” but the reverse is true.
The LKP Series Measuring Heads require special repair procedures and materials.
However, the heads are very reliable and should require little or no repair over its service
life. Please refer to the nearest authorized DynAmp service center for information on
repairs.
TABLE 7.1
SPARE PARTS LIST *
DESCRIPTION
ITEM NO.
QUAN
Metering Unit
Kit, Spare Parts, LKP-100
43790
1
Spare Parts Kit includes Module, Fuses and Bulb as one package
LKP Hi Range Module “A”
41413
1
Bulb, POWER ON light
42121
1
**Fuses, LKP-100 (channel fuse, 4 Amp) (5 per box)
12592
2 box
**Fuse, Module ac Supply (located on TS3-7, 6.25 Amp) (All)
12594
2
Options
***Accuracy diagnostics PCB, (4) Channel main board (1 used on
Module A)
41314
1
***Accuracy diagnostics PCB, (2) Channel main board (1 used)
40402
1
***Accuracy diagnostics PCB, (4) Channel main board (1 used)
40355
1
*
For one to five units, stock the quantities shown. For six or more units, a complete
system (head, cable, and Metering Unit) should be kept on hand.
**
All Fuses are Time lag MDA style 3AB ¼” by 1 ¼” (6.3 mm x 32mm), 250 Volt
***
Only required if accuracy diagnostics option is installed.
Disconnect power to the system before servicing or replacing fuses.
