Dynamix DC – 16 S/SA 16 ports SHDSL DSLAM modem/router
User Manual
Installation
The Dynamix DC-16S/SA can be installed in a standard 19-inch rack, by
using the mounting brackets provided. Mount the shelf on the rack using the
large screws provided.
Safety Instruction
The following is the safety instructions for Dynamix DC-16S/SA before installation:
1. Read and follow all warnings and instructions of this user manual.
2. The maximum recommended operating temperSTUre for the Dynamix DC-
24S is 50ºC. Sufficient air circulation or space between units is crucial when
Dynamix DC-16S/SA is installed inside a closed rack assembly and racks
should safely support the weight of Dynamix DC-16S/SA.
3. The power supply to Dynamix DC-16S/SA should be capable of operating
safely with the maximum power requirements of the Dynamix DC-16S/SA. In case
of
power overload, the supply circuits and wiring should not cause hazardous.
4. The AC adapter must be plugged in to the right supply voltage. Make sure
that the supplied AC voltage is correct and stable. If the input AC voltage is
over 10% lower than the standard may cause malfunction to Dynamix DC-16S/SA.
5. Do not allow anything to rest on the power cord of the AC adapter, and do not
locate the product where anyone can walk on the power cord.
6. Generally, after the final configuration, the product must comply with the
applicable safety standards and regulatory requirements of the country in
which it is installed. If necessary, consult for technical support.
7. A rare condition can create a voltage potential between the earth grounds of
two or more buildings. If products installed in separate building are
interconnected, the voltage potential can cause a hazardous condition.
Consult a qualified electrical consultant to determine whether or not this
phenomenon exists and, if necessary, implement corrective action before
interconnecting the products. If the equipment is to be used with
telecommunications circuit, take the following precautions:
Hardware Installation
Describes how to connect Dynamix DC-16S/SA to CPE. Hardware
installation will be described in the following procedures.
