4-7
4. Operation
(4) Set the operating condition (see section 4.1).
(5) Start the operation.
Press the START button.
■
The START LED starts blinking.
■
When
it reaches the set speed,
START LED stops blinking and stays lit.
(6) End the operation.
Wait until the TIME indicator shows “0” or press
the STOP button.
■
As the rotor starts decelerating,
the STOP LED starts blinking.
■
When the rotor stops, the STOP LED stops blinking and stays lit. Stop signal
starts sounding. If you select “no tune”, all indicators blink upon halt of the rotor.
■
In the Velocity 15HR centrifuge, the door lock is not released automatically to
prevent dew drops. When using Velocity 15HR, press the OPEN button to unlock
the door.
(7) Open the door gently and take out the sample.
■
Do not open the door roughly, otherwise the separated sample might be disturbed.
(8)
Turn off the POWER switch.
■
In the Velocity 15HR centrifuge, turn off the POWER switch with its door open to dry
the rotor chamber at the end of daily operation.
If the Velocity 15HR centrifuge will not be used for a long time, turn off the POWER
switch with its door open as well as the above.
CAUTION
：
●
Some tubes that are sold on the market have lower allowable speeds (allowable
RCF) than the rotor in use. Use them at the lowest allowable speed or less.
！
S TAR T
S TO P
S TAR T
S TO P
Summary of Contents for Velocity 15HR
Page 2: ......
Page 58: ...MEMO ...
