Dynamica Velocity 15HR, Instruction Manual

Page: 14 / 60

2-2
2. Installation
This section describes instructions you need to follow when installing the centrifuge.
This instructions ensure your safety and the maximum performance.
(2) Power source
Velocity 15HR:
120 V instrument: 108-126 V AC, 15 A, 60 Hz
220-230 V instrument: 198-253 V AC, 10 A, 50 Hz ; 198-242 V AC, 10 A, 60 Hz
 Install an emergency switch (circuit breaker) that turns off the main power supply
in the event of a malfunction. Optimally, install the emergency switch outside the
room or near the exit.
(3) Connection of the power cord
 Connect the attached power cord to the inlet of the centrifuge.
 Check that the POWER switch is turned off. Then plug in to the outlet.
(4) Removing the packing for transportation from the rotor chamber

Unlock the door by pressing the OPEN button after turning on the POWER
switch. Remove the packing for transportation from the rotor chamber after
opening the door.
WARNING
：
●
To avoid electrical shocks, do not touch the power cord with wet hands.
●
Do not hold the cord when disconnecting the power cord from the outlet.
Hold the plug when disconnecting it.
●
This centrifuge must be grounded properly.
The power cord plug has a three-prong plug. One of the three prongs is provided
for grounding. This centrifuge can be grounded just by putting the three- prong plug
into a three-prong outlet.
Do not connect the three-prong plug to a two-prong outlet using an adapter.
！
CAUTION
：
●
For connection to a different outlet, the power cord may be needed to be replaced.
Follow local electrical codes.
！
Velocity 15HR
Power cord
Inlet