Dynamic DX-REMG91, Installation Manual

Page: 76 / 80

GBK63648
:
Issue 3
– February 2012
70
Most electronic equipment is influenced by radio frequency interference (RFI). Caution
should be exercised with regard to the use of portable communications equipment in
the area around such equipment. While Dynamic Controls has made every effort to
ensure that RFI does not cause problems, very strong signals could still cause a
problem. It is the responsibility of the vehicle manufacturer to ensure that the vehicle is
tested in accordance with local EMC regulations.
If RFI causes erratic behaviour, turn the vehicle off immediately. Turn the vehicle off
before using cell phones or portable communications devices.
In the event of the system status LED/indicator flashing while driving, the operator must
ensure that the system is behaving normally. If not, the system must be turned off and a
service agent contacted.
Report any malfunctions immediately to your service agent.
Service and Configuration Warnings
The following warnings are applicable to the installer only.
It is the responsibility of the therapist/ installer to ensure the final set-up of the vehicle is
appropriate for the specific abilities of the particular end-user in terms of safety and
performance.
After the vehicle has been configured, check to make sure the vehicle performs to the
specifications entered in the programming procedure. If the vehicle does not perform to
specifications, reprogram it. Repeat this procedure until the vehicle performs to
specifications. If the intended operation cannot be achieved, contact your service agent.
The completed installation must be thoroughly checked, and all programmable options
correctly adjusted, for safe operation prior to use.