Dynamic DX-REMG91, Installation Manual

Page: 34 / 80

GBK63648
:
Issue 3
– February 2012
28
3.10 The Joystick
The joystick for the G91 is always provided in the form of a
secondary remote such as a DX-RJM.
Moving the joystick will cause the powerchair to drive in that
direction. The amount of joystick movement will determine
the speed that the powerchair will move in that direction.
The programmable parameter Short Throw Travel allows the
amount of movement required to drive the chair in any
direction at full speed to be customized. For details on
correct use of this parameter please refer to Section 6.5 -
Programmable Joystick Throw/Shape
The programmable parameter Joystick Switch Threshold
determines the amount of joystick movement to operate
accessory modes, such as actuators.
Joystick Out of Neutral at Power up (OONAPU) occurs
if the joystick is out of neutral when switched on. If this
happens the System Status LED will flash constantly.
Releasing the joystick within a few seconds will cancel the
indication otherwise a „latching fault‟ will occur. If the user
has difficulties switching the power on without moving the
joystick, use the parameter
Disable OONAPU Faults .