20
HOW TO REPLACE FRONT WHEEL
1. Remove the axle cap by sliding a flat head screwdriver along the edge of the cap
and carefully prying the cap open.
2. Use needle nose pliers to remove the split pin in the hole of the front axle end.
3. Remove the M10 locknut with a 17 mm socket wrench.
4. Remove the Ø12 washer.
5. Remove the wheel, then replace with a new wheel.
6. Remount the Ø12 washer and M10 locknut and securely tighten the wheel.
NOTE
: Do not over-tighten.
7. Insert a split pin into the hole in the end of front axle, and split it using standard
needle nose pliers.
8. Reinsert the axle cap.
TOOLS REQUIRED:
Phillips Screwdriver
(not included)
Flat head Screwdriver
(not included)
17 mm Socket Wrench
(included)
DETAILED MAINTENANCE AND REPAIR
F
Needle-Nose Pliers
(not included)
IMPORTANT:
Check wheel gap (see page 10).
WARNING:
Disconnect power supply before conducting any maintenance
procedures.
Front Axle
Front Wheel
Split Pin
Axle Cap
Ø12
Washer
M10
Lock Nut
