Dynacord DPA 8150, User Manual

Page: 34 / 46

Rated output power, 1 kHz, THD < 0.5%, two
channels driven 500 W
Max. RMS voltage swing, 1 kHz, THD = 0.2%,
without load 56 V 80 V 115 V
Voltage gain, ref. 1 kHz 30.2 dB 33.1 dB 36.2 dB
Input sensitivity, rated power at rated load,
1 kHz +6 dBu (1.55 Vrms)
THD at rated output power, MBW = 80 kHz,
1 kHz < 0.5%
IMD-SMPTE, 60 Hz, 7 kHz, half rated output
power < 1.0%
DIM 30, 3.15 kHz, 15 kHz < 0.4%
Input level, max. +18 dBu (6.15 Vrms)
Frequency response, ref. 1 kHz, rated load 50 Hz (-3 dB) to 20 kHz (-6 dB)
Input impedance, active balanced 20 kOhms
Damping factor, 1 kHz, rated load > 5
Slew rate 24 V/µs
Signal to noise ratio, A-weighted > 104 dB
Output noise, A-weighted < -66 dBu
CAN port 10 to 500 kbit/s, 2 x RJ-45
Control port 1 x 8-pin connector
3 control inputs/outputs (max. 60 V/1 A)
2 reference outputs (15 V/100 mA and
GND/100 mA)
1 ready/fault output (max. 30 V/1 A)
Output stage topology Class-D, transformer, floating
Power requirements 115 V/230 V AC (-10%/+6%), 50 to 60 Hz or
24 V DC (-10%/+30%)
Power consumption, AC and DC See table below
In-rush current 12 A
In-rush current, after five-second power cycle 7 A
Mains fuse 230 V (-10%/+6%): T5A
115 V (-10%/+6%): T10A
Monitor
• Rated output voltage 4.5 dBu (1.3 V)
• Rated load impedance 600 ohms
Ground fault R < 50 kOhms
34 en | Safety information PROMATRIX 8000 POWER AMPLIFIER
19-Aug-13 | 03 | F01U217494 User manual