Dynacord DPA 8150, User Manual

Page: 15 / 46

Figure 6.2: Audio input unbalanced cabling
Power outputs on the output stage
The audio outputs on the DPA output stage are galvanically isolated and are constantly
monitored for ground fault. The scope of delivery for the device includes a 6-pin connector.
Conductor cross-sections of 0.14 mm² (AWG26) to 1.5 mm² (AWG16) can be used.
Recommended connecting cable: flexible CU strand, LiY, 0.75 mm².
For ease of installation, the connector can be removed. With regard to the maximum number
of speakers that can be connected, speakers can be connected until the point at which the
total power consumption of the speaker network corresponds to the nominal power value of
the output stage, where the rated load resistance of the output stage outputs is not to be
exceeded. The nominal power values and the rated load resistances of the outputs can be
found in the section entitled Technical data, page 33. Please also refer to the section entitled
“Integrated relays” below.
Notice!
Outputs on the DPA 8150
Outputs F, G, and H on the DPA 8150 are arranged in ascending order from left to right.
6.2
PROMATRIX 8000 POWER AMPLIFIER Safety information | en 15
User manual 19-Aug-13 | 03 | F01U217494