Installing the Panel Assembly
Install the panel assembly according to the following procedures:
1.
Seat and adhere the Hinges in the correct position on the LCD cover assembly as shown in
Figure 4-29 (Tighten the six M2×2.5 screws).
2.
Seat and adhere the antennas in the correct position on the LCD cover assembly as shown in
Figure 4-29 (. (Tighten the two M2×3.0 screws)
3.
Seat and adhere the Camera in the correct position on the LCD cover assembly as shown in
Figure 4-28.
4.
Seat and adhere the Antenna module in the correct position on the LCD cover assembly as
shown in Figure 4-27.
5.
Place the panel assembly upside down so that the bottom is facing up.
6.
Connect the eDP cable to the panel connector and lock it with lock bar, then adhere the mylar over
the connector to secure it in place as shown in Figure 4-23.
7.
Connect the eDP cable FFC to the camera FPC board connector as shown in Figure 4-22.
8.
Pull up the blue release paper of Panel Adhesive from LCD cover as shown in
Figure 4-24.
9.
For Panel P30 type: Rotate the panel right-side up and use 0.5mm Mylar between LCD cover and
Panel to seat it in the correct position as shown in Figure 4-25.
10.
For Panel P20 type: Rotate the panel right-side up and use 1.25mm Mylar between LCD cover and
Panel to seat it in the correct position as shown in Figure 4-26.
