Figure 4-16 Location of Electronic tape & Conductive tape
Installing the Touch Pad Module
Install the touch pad module according to the following procedures:
1.
Seat the touch pad in the correct position on the logic upper assembly
□
,5.
2.
Seat the TP support bracket in the correct position on the logic upper assembly
□
,4 and tighten
two M2×2 screws to secure the tp support bracket to the logic upper assembly
□
,3.
3.
Connect the touch pad FPC to the touch pad
□
,1
□
,2.
4.
Adhere the conductive tape over the touch pad and logic upper assembly as shown in Figure 4-16
□
,6.
