USE R GUI DE
|
P OR T A -R AY
®
4 0 0 R
7
is latched to the bottom Accessory Compartment or to
hold the Lamp Head during manual curing operations.
•
Lamp Power Select Switch (D) -
The Lamp Power
Select Switch selects either the “full” or “standby”
lamp power setting. When curing or warming up the
Lamp, the Lamp Power Select Switch should be set to
full power. Between curing operations, the Lamp
Power Select Switch can be set to the half-power
standby setting, which reduces the amount of heat and
stray UV light radiated by the unit. The Lamp Power
Select Switch should always be set to “standby” when
the Lamp Head is idling on the Headrest. When
switching back to full power, the Lamp will be ready for
curing again after a brief 10-second re-warming period.
•
Input/Output Cooling Air Louvers (E & F) -
The Input
and Output Air Louvers channel cooling air from the
Fan in and out of the Lamp Head. These must remain
unobstructed.
•
Cooling Fan (G) -
The Lamp Head Fan cools the
Lamp, Reflector, and Internal Power Supply Circuit-
Board Assembly.
•
Arc Bulb (H) -
Medium-pressure Arc Bulb which
produces UV and visible light.
•
Reflector (I) -
Lamp Reflector which collects and
concentrates light from all sides of the Arc Bulb. This
surface should be kept clean to ensure maximum light
output.
•
Accessories Storage Compartment (J) -
The
Accessories Storage Compartment can be used to
store and transport curing accessories (i.e. headrest,
glasses, power cord, and adhesive).
•
Lamp-Head Latches (K) -
The Lamp-Head Latches
are used to secure the Lamp Head to the bottom
Accessories Storage Compartment during transport
and storage.
Figure 2.
Lamp-Head Unit, Top View
Figure 3.
Lamp-Head Unit and Storage Compartment
(D) Lamp Power
Select Switch
(A) Mounting Holes
(C) Handle
(F) Input Air Louvers
(G) Cooling
Fan
(H) Arc Bulb
(I) Reflector
(J) Accessories Storage
Compartment
(K) Lamp Head
Latches
(E) Output Air Louvers
(B) Input
Power Switch
& Receptacle
