- 4 -
SMALL
END
LARGE
END
LARGE
END
VALVE
OUTLET
VALVE
OUTLET
PUTTY
1
2
3
1
4
8
5
6
7
7
9
9a
HOT
FRONT
COLD
FERRULE
COMPRESSION
NUT
COUPLING NUT
FLEXIBLE
SUPPLIES
3/8 O.D.
BULL-NOSE
RISERS
1/2" PIPE
THREAD
3/8 COMPRESSION
CONNECTION
CONNECT TO
WASTE OUTLET
10
11
8
9
10
ATTACH CABLE
CONNECTOR
CHECK OPERATION OF POP-UP
INSTALL SUPPLY HOSES
• POP-UP KNOB
(1)
must be fully
down.
Fig. A.
• Thread CABLE CONNECTOR
(1)
clockwise onto DRAIN BODY
CONNECTION
(2)
and hand
tighten.
Fig. B
.
Your new POP-UP DRAIN
installation is now complete.
Fig. C.
Note: Tailpeice on pop-up drain
is 1-1/4
"
O.D. Fig. C.
• Operate LIFT KNOB
(1)
to verify that STOPPER
(2)
opens and closes.
Fig. A.
Note: If STOPPER (2) does not open and close
properly then refer to the “troubleshooting
section” of theseinstructions.
INSTALL DIVERTER HANDLE
• DIVERTER HANDLE
(1)
onto VALVE STEM
(2)
of DIVERTER.
Fig. B.
• Secure with DIVERTER HANDLE SCREW
(3)
.
• Thread HANDLE CAP
(4)
onto DIVERTER HANDL
E (1)
.
Connect small end of SUPPLY HOSES
(1)
TO “Y”
ADAPTER
(2)
and larger end to each VALVE OUTLET.
Important: Loop SUPPLY HOSES (1) as illustrated
so they do not kink.
INSTALL SPRAY BODY
• Apply putty to the underside of SPRAY BODY FLANGE
(3)
and install SPRAY BODY
(3)
into spray hole of Bidet.
• From underside of Bidet install RUBBER WASHER
(4)
,
FIBER WASHER
(5)
and LOCKNUT
(6)
onto shank of
SPRAY BODY
(3)
. Tighten LOCKNUT
(6)
to make water
tight seal.
• Connect one end of SPRAY HOSE
(7)
to HOSE ADAPTER
(8)
and the other end to shank of SPRAY BODY
(3)
.
Tighten hose connections to make a water tight seal.
WATER SUPPLY CONNECTION
NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS
NOT INCLUDED AND MUST BE PURCHASED SEPARAT
ELY.
• Connect water supply to VALVE BODIES
(9,9a)
with 1/2
"
IPS FLEXIBLE
SUPPLIES
(10)
or 3/8
"
O.D. BULL-NOSE RISERS
(11)
. Use adjustable
wrench to tighten connections. Do not over tighten. Be careful not to
kink copper supply when bending. Use tubing cutter to cut to proper length.
• | Connect HOT water supply to inlet of left SHANK and COLD water supply to right
SHANK using sealant, appropriate connectors, and COUPLING NUTS.
• Connect 1-1/4
"
O.D. tailpiece on POP-UP DRAIN to waste outlet.
1-1/4” O.D.
1
2
DOWN
Fig.
A.
Fig.
B.
Fig.
C.
2
1
Fig.
A.
Fig.
B.
4
3
1
2
M965497 Rev. 1.6 (5/17)
