- 2 -
M965497 Rev. 1.6 (5/17)
1
2
INSTALL HANDLES
INSTALL CONTROL VALVES
• Turn VALVES to off position. Align HANDLES
(1)
as shown or
as desired and install onto HANDLE ADAPTER
(2)
. Tighten SET
SCREW
(3)
with HEX WRENCH
(4)
supplied. Push PLUG
BUTTON
(5)
into place.
• Apply sealant or Teflon tape to threads of SPRAY ELL
(1)
and install into TRANSFER
VALVE
(2)
.
Note: Arrow on SPRAY ELL (1) points down, see illustration
.
• Install “Y” HOSE ADAPTER
(3)
with SEAL
(4)
to bottom nipple of
TRANSFER VALVE
(2)
and tighten to make a water tight seal.
• Install LOWER CONE SEAL
(5)
onto TRANSFER VALVE
(2)
and
insert TRANSFER VALVE
(2)
from under side of Bidet into the
center forward hole.
• Install UPPER CONE SEAL
(6)
, FRICTION WASHER
(7)
and
MOUNTING NUT
(8)
onto TRANSFER VALVE
(2)
.
• Tighten MOUNTING NUT
(8)
to secure the TRANSFER VALVE
(2)
and make a water tight seal.
• Thread TRANSFER VALVE ESCUTCHEON
(9)
onto MOUNTING
NUT
(8)
. until snug against bidet ledge.
INSTALL TRANSFER VALVE
CAUTION
Turn off hot and cold watert
supplies before beginning.
2
FRONT
4
1
3
5
18
14
15
19
17
16
6
7
13
20
12
10
11
8
9
COLD
HOT
BIDET
LEDGE
GROOVE
APPLY TEFLON
TAPE
10˚
10˚
1-1/2"
(38 mm) MAX.
3
5
4
2
1
• Unpack valve assembly and remove HANDLE
(10)
by unthreading
SET SCREW
(11)
. Unthread ROSETTE
(12)
and FLANGE
(13)
removing them from VALVE BODY
(14)
.
• Thread LOCKNUT
(15)
to bottom of VALVE BODY
(14)
. Make sure
SPACER
(16)
, BRASS WASHER
(17)
and RUBBER WASHER
(18)
are installed.
• Insert VALVE BODY
(14)
through mounting hole from underside
of bidet ledge.
Note: VALVE BODY marked Hot is installed in the left Mtg. hole,
VALVE BODY marked Cold in the right when facing front
of fitting.
• Install STOP RING
(19)
onto VALVE BODY
(14)
if not in place.
Install O-RING
(20)
into groove in FLANGE
(13)
.
• Thread FLANGE
(13)
flush against STOP RING
(19)
.
Thread
ROSETTE
(12)
onto VALVE BODY
(14)
until tight against it’s internal stop.
• Align VALVE BODY
(14)
as shown and from below tighten LOCKNUT
(15)
to secure VALVE BODY
(14)
.
