- 5 -
M965497 Rev. 1.6 (5/17)
11
TEST INSTALLED FITTING AND CONNECTIONS FOR LEAKS
• With FAUCET HANDLES in OFF position, turn on WATER SUPPLIES
(1)
and check all connections for leaks.
• Operate both handles to flush water lines thoroughly. Turn diverter to rim wash and bidet spray.
• Operate LIFT ROD
(2)
and fill bidet with water. DRAIN STOPPER
(3)
should make a good seal and retain water
in bidet. If DRAIN STOPPER
(3)
does not make a water tight seal see “Troublingshooting Guid” section in
these instructions
• Release DRAIN STOPPER
(3)
and check all drain connections and “P” trap for leaks. Tighten if necessary.
NOTE: Diverter valve is not a positive shut-off to rim wash.
1
1
2
3
