DWT ESP01-250, Original Instructions Manual

Page: 20 / 132

20
English
• Follow instruction for lubricating and changing ac-
cessories�
Safety guidelines during
power tool operation
Before commencing operation
• Spraying inflammable materials increases the risk of
fire or explosion, so please follow all the required pre -
cautions and ensure that there are fire-extinguishing
means on site�
• After handling inflammable materials (for example,
after mixing or thinning paint or after cleaning any parts
of the power tool) remove all used containers and the
cloth, as they may cause fire.
• Make sure that the area where the works will take
place is properly ventilated - gases or vapors gener-
ated during work may be harmful to your health and
increase the risk of fire or explosion.
• Do not work near the sources of open fire or sparks,
hot objects, engines�
• Do not spray materials having a flash point
below 21°С - this increases the risk of fire or explosion.
• Prior to spraying the material, carefully read manu-
facturer's instructions in order to undertake the appro-
priate safety measures�
• Do not spray unknown materials or materials with
unknown dangers�
• Do not spray any materials that can damage the
power tool; if the power tool breaks as a result, your
warranty will be voided� Spraying acids, alkalis, materi-
als containing abrasive particles, materials containing
lead, liquid glass, excessively thick materials, and oth-
er materials that are difficult to spray or to form drops
is strictly prohibited�
• Install the base unit 11 onto the horizontal vibration-
free surface� The air sucked through the holes of the
cover 8 must be clean; therefore, do not use the base
unit 11 in a dusty environment; also make sure that
the cover 8 is not covered by anything (only for model
ESP05-200 T
)�
During operation
• Use personal protective equipment - special cloth-
ing, glasses, gloves, and closed shoes�
• Use special masks intended for the protection of
respiratory system from harmful substance vapors�
Please note! The use of dust masks or respirators
will not assure the required effect - you may suffer
severe intoxication.
• Smoking during spraying inflammable materials is
strictly prohibited�
• While working, do not direct the stream of the
sprayed material onto yourself, other individuals,
or animals� The stream may pierce your skin (even
through gloves) and inject the sprayed material - in
such a case seek medical attention immediately�
• Please bear in mind that during working the sur-
rounding air fills with "mist" consisting of fine drop -
lets of the sprayed material that subsequently settles
on surrounding surfaces� The surfaces on which the
"mist" precipitation is unwanted should be covered�
When working outside, the "mist" is exposed to wind,
which may lead to negative consequences (unwanted
painting of objects, causing harm to health, environ-
mental contamination)�
• Do not switch on the power tool if there is no liquid in
the reservoir - dry running causes rapid wear of power
tool components�
After finishing operation
• The power tool must be cleaned after each use as
described below� Failure to clean or improper cleaning
may cause breakage of the power tool, which will void
the warranty�
• Dispose of the sprayed material residues (paint
materials, solvents, etc�) in strict compliance with the
manufacturer's instructions�
Symbols used in
the manual
Following symbols are used in the operation manual,
please remember their meanings� Correct interpreta-
tion of the symbols will allow correct and safe use of
the power tool�
Symbol Meaning
ESP ...
Serial number sticker:
ESP ��� - model;
XX - date of manufacture;
XXXXXXX - serial number�
Read all safety regulations
and instructions�
Wear safety goggles�
Wear ear protectors�
Wear a dust mask�
Disconnect the power tool
from the mains before instal-
lation or adjustment�
Movement direction�
Rotation direction�
Locked�
Unlocked�