29
• VIEW ANGLE SETUP
VIEW ANGLE SETUP
PANNING RANGE
FLIP : 90
q
TILT ANGLE LIMIT : 07
q
SAVE AND EXIT(ESC TO CANCEL)
FLIP
OFF, AUTO, 90
q
, 100
q
, 110
q
and 120
q
OFF:
The dome camera moves until 90
q
vertically.
AUTO:
When the camera reaches the floor directly above the moving object, it will stop.
At that time, pull it down again to run the auto-flip function. When you use the panning range, it is
recommended to use the flip mode to AUTO.
90
, 100
q
, 110
q
and 120
q
:
Allows the image to flip digitally when the camera moves over the setting
angle vertically.
TILT ANGLE LIMIT
-10
q
~ 10
q
This option is designed to limit the view angle as there is some obstruction in zooming out on specific
areas of the tilt angle.
NOTE:
Focus issues may occur in certain conditions.
PANNING RANGE
When the dome camera is installed near a wall, panning range can be limited by user.
PANNING RANGE SETUP
(CTRL KEY)
RIGHT LIMIT : 000.0
LEFT LIMIT : 000.0
ENABLE : OFF
SWAP : OFF
AUTO PAN : ON
SAVE AND EXIT(ESC TO CANCEL)
1. Place the dome camera under 90 degree vertically.
2. Set “
RIGHT LIMIT
” by pressing the
Right
key.
3. Set “
LEFT LIMIT
” by pressing the
Left
key.
4. Set “
ENABLE
” to ON to use.
To exchange the right and the left limit, set “
SWAP
” to ON.
To apply limits on the auto pan (endless panning), set “
AUTO PAN
” to ON.
NOTE: When the flip mode is 90
q
, 100
q
, 110
q
or 120
q
and the camera’s view is manually moved
over 90
q
vertically, the panning range will operate in the opposite side.
