H40, H50, H50VSD-C
Jul ‘17
- 3 -
Quick Start (cont’d)
Shipping Cleats.
Your DV Systems ‘H Series’ Rotary Screw Compressor is shipped with several Shipping Cleats that
must be removed prior to the initial start-up.
The Cleats are located a) (1) under the Air End Mount and b) (1) under the Motor of the Unit. Please
remove these after locating the Unit but prior to running. Motor and Air End are orientated differently in
VSD and Belt Drive Units, Cleats can be located as shown below.
Air End Cleat Removal.
Motor Cleat Removal.
The Motor is fastened to the Unit framework by means of (1) Shipping Cleat as indicated below. Access to the
Cleat is by means of both the front and rear of the Unit.
Remove the fasteners and slide the Cleat out of the assembly.
Fasteners
H50 VSD
Locate the Air End Mount at the back of the Unit.
Locate the orange Shipping Cleat under the Air End Mount.
Remove the Bolt and Washers from the Cleat, and slide the Cleat out.
H40/50 BD
(1) Cleat at
Air End
Motor Cleat from the Front of Unit.
Motor Cleat from the Rear of Unit.
Shipping Cleat
Fasteners
Shipping Cleat
