Page 7 of 24
3. Instructions
3.1 Preparation
This DV Signage monitor is designed to be as plug and play as possible requiring the minimum of
setup for use. The following describes the operation of this monitor unit.
Please make sure the whole package in the box includes the items below :
15.6” monitor
Power supply
Power cord
3.2 Powering On
Connect the provided external AC power supply unit.
Power on the unit using the Power on/off switch, the status LED should come on.
This LED indicates the controller status.
State
Status LED color
No signal & backlight off
RED
No signal & backlight on
ORANGE
With signal & backlight on
GREEN
3.3 Signal input
Analog VGA / HDMI / Display Port / SDI :
Analog VGA Input
: As this may affect regulatory emission test results and the quality of the signal
to the controller, a suitably shielded cable should be utilized. Plug the VGA cable to “VGA” connector
on the monitor.
HDMI input :
Support HDMI 1.3 input up to 1080p/WUXGA resolution.
Plug the HDMI cable to
“HDMI” connector on the monitor.
Display Port Cable :
Support single-link Display Port 1.1a. Plug the Display Port cable to the
“Display Port” connector on the monitor.
SDI Input :
3G/HD/SD-SDI signal input support. Plug the coaxial cable to the BNC connector.
SDI re-clock loop out :
3G/HD/SD-SDI re-clock loop out. Recommend to connect less than 100
meter in good co-axial cable (e.g Belden 1694A) between Digitalview devices.
