7
RMO40TD Description
5
Description
5.1 Front Panel Components
STOP
Press to stop a test or stop the alarm buzzer.
START
Press to start a test
Test parameters must be selected beforehand
Pressing
START
at the same time with
SET
allows you to go to setting menu for the language, time and
date settings.
Ω
Press to measure the resistance current value.
Press to measure the resistance value in TapC mode
Green LED
• Lights continuously when RMO40TD is turned on.
• Flashes when a test can be started.
• Flashes alternately with the red LED during a test.
Red LED
• Lights continuously in case of operational error.
• Lights continuously during discharging process.
• Flashes alternately with the green LED during the Current test.
• Flashes shortly during resistance measurement in the TapC test.
• Flashes alternately with the green LED during the TapC test.
Red LED - Discharge
•
The red LED just above the red output connector remains lit until the accumulated energy of the
measured object is reduced to a harmless level
CAUTION
Within the period when the discharge LED lights it is prohibited to disconnect measuring cables.
The discharge diode cannot be switched off by pressing
STOP.
Display
UP/DOWN
buttons to select a
menu and set test parameters
LEFT/RIGHT
buttons to navigate in the active
menu
ENTER
button to
confirm the defined test
parameters, Language,
Time and Date
STOP
button to stop a
test, to acknowledge the
alarm buzzer and return
to the
Curr
menu.
Ω
button to measure the
resistance current value
and the resistance and
the ripple value in TapC
mode.
START
button to start
the test current.
SET
button to scroll
between the
Curr
menu, the
TapC
menu
and the
Memory
menu
