CLEANING PROCEDURE
Dustbane Products Limited
Push down on handle to raise
vacuum shoe and brush before
moving to the next cleaning pass.
Overlap brush contact area
approximately 1inch.
During operation, observe the following:
The FB10 is equipped with clear
internal covers to facilitate operator
viewing of dirty solution and vacuum air
flow. During operation, observe the
vacuum intake cover. Large amounts of
water or foam entering the vacuum
system can damage the vacuum motor.
If you notice either condition,
shut
down the machine immediately
.
Empty recovery tank and/or add
defoamer to recovery tank.
STEP
2
STEP
3
STEP
4
Start at wall closest to power outlet.
Pull straight back without pushing
down on handle.
STEP
1
1ft.
(30cm)
OFF
Release intermittent setting or turn
off continuous setting on brush/spray
switch approximately 1 foot before
ending cleaning pass.
1in.
(25mm)
VACUUM
INTAKE COVER
SOLUTION
INTAKE COVER
3-8
