To adjust cutting pressure
Adjustment
For a flawless cutting operation it is important for screw 4 in the free
arm to be up against the counter cutter support with a slight pressure
and in this way it cannot be pressed down.
Correction
–
Undo screw 4 a little and then screw it in slightly again on the
counter cutter.
–
Swing the thread draw cutter out until the arrow on the cutter
points towards the edge of the counter cutter.
–
Undo screw 1.
–
Place the thread draw cutter 2 against the counter cutter.
–
Tighten screw 1.
Important
The eccentric cut of the thread draw cutter 2 automatically produces a
cutting pressure when both cutting edges are on top of each other.
41
GB
3
2
1
4
Summary of Contents for M-Type 869
Page 4: ......
