WARNINGS
Before using this unit please read these instructions carefully. Take special care to follow the
warnings and safety suggestions listed below. Keep these instructions for future reference.
SAFETY WARNING
1. Proper installation of this product requires the installer to have a good understanding of
automotive electronics, systems and procedures.
2. If mounting this product requires drilling holes, the installer MUST be sure that no vehicle
components or other vital parts could be damaged by the drilling process. Check both sides
of the mounting surface before drilling begins. Also de-burr the holes and remove any metal
shards or remnants.
3. Do not install this product or route any wires in the deployment area of your air bag. Equip-
ment mounted or located in the air bag deployment area will damage or reduce the effective-
ness of the air bag, or become a projectile that could cause serious personal injuryor death.
Refer to your vehicle owner’s manual for the air bag deployment area. The User/Installer as-
sumes full responsibility to determine proper mounting location, based on pro-viding ultimate
safety to all passengers inside the vehicle.
4.Do not attempt to activate or control this device in a hazardous driving situation.
5. This product contains either strobe light(s), halogen light(s), high-intensity LEDs or acombi-
nation of these lights. Do not stare directly into these lights. Momentary blindnessand/or eye
damage could result.
6. All connections must use waterproof connectors and any unconnected wires must be sealed
to prevent water ingress via the wire core, failure to do this may result in premature failure
and invalidate the warranty.
7. Use only soap and water to clean the outer lens. Use of other chemicals could result inpre-
mature lens cracking (crazing) and discoloration. Lenses in this condition have significantly re
-
duced effectiveness. Inspect and operate this product regularly to confirm its proper operation
and mounting condition. Do not use a pressure washer to clean this product.
8. It is recommended that these instructions be stored in a safe place and referred to when
performing maintenance and/or reinstallation of this product.
9. For this product to operate at optimum efficiency, a good electrical connection to chas
-
sisground must be made. The recommended procedure requires the product ground wire to be
connected directly to the NEGATIVE (-) battery post.
