Page
38
Dura
®
LIFESTYLE
LIFESTYLE
Whitford
6.7 Handle fitment
• Fit handle (F) to the outside of the door using the
supplied screws (P), nuts, and washers.
• Complete drilling holes with 5mm drill bit, through
pre-drilled holes on the back of the door.
Legs
Nylofelt
Legs go
under
Nylofelt and
snap over
curtain edge
6.8 Lift lock centring
• Raise the curtain until the lock corrugation is visible above door
guides.
• Install locking bar retainer (I) in line with lock corrugation by
pushing retainer towards door edge, sliding the legs under the
Nylofelt® and hooking them over the curtain edge. Ensure lock
bar retainers sit squarely on door curtain.
• Fit faceplate (H) to outside of door, where the hook will latch
onto curtain edge. Then, slide the faceplate as far to the right
as possible. Use adhesive tape on outside to hold in position.
• Attach the lock body (H) to the faceplate from the inside, using
the mounting screws and washers. Do not overtighten the
screws.
• With the door in the closed position, slide the end of the
locking bars (D) through the locking bar retainers, and while
holding the bars level, mark the side of the guides.
• Drill and file out a rectangular slot no longer than 25mm and
no wider than 10mm, ensuring top of the slot remains in line
with top of the locking bar.
• Slide bars through the guide slot, then back onto locking arms.
Note:
These may need to be cut shorter.
• Screw on securely using the countersunk screws (O). Ensure locking bars do not protrude more than 20mm
beyond guide when engaged in locked position. It may be necessary to adjust the length of the bars.
• Ensure a clean and dry guide using clean rag.
• Peel lining from lock bar cover (J) and position over hole. Ensure locking bars move freely.
Lock bar covers
must be installed
to prevent possible
finger entrapment.
Hook
Lock corrugation
• Remove all swarf (drill filings) with a soft brush or rag.
• Hose down roof and walls thoroughly.
• For Coloursteel sheds, use touch-up paint provided on all rivets and exposed cuts.
6.9 Clean-up