13
12
In case the DLC-010 is at
the start or end position of
the CAN bus, make sure to
switch the CAN load switch
to the right position.
230VAC
PLP-REM-350
The DLC-010 can be connected to a PLP-REM-350 to allow control
of the DuraCover System using the LINKTouch*. Connection between
DLC-010 and PLP-REM-350 can be done using the CAN bus interface.
1. Connect the power cables, DuraCover motor, sensors & key switch: Fol-
low the instructions on page 6.
2. Make sure DIP switch 1 is set to the ON position
3. A twisted pair cable needs to be connected between the DLC-010 CAN
terminal blocks (nrs 7 & 8) and the PLP-REM-350 CAN connector.**
Respect the polarity of the terminals! (CAN L & H)
CAN BUS
* The DLC-010 can always be controlled with a Key-switch, even when a LinkTouch is confi gured
** We recommend using a shielded twisted pair cable (min. 0,5mm² - up to 200m)
!
DLC-010
DLC-010 in combination with LinkTouch & PLP-REM(-350)
Installation instructions
ON
Calibration
To start calibration via the LinkTouch, DIP switch 1 must be set to ON.
1. Touch the display on the LinkTouch for 3 seconds to go into the settings
menu.
2. Use the right arrow key to select: PLP-REM (enter), then touch the display
to confi rm
3. In the next menu, make sure the AUX Setting is set to “COVER”, then
touch the left arrow key
4. Use the right arrow key, to select: COVER SETTINGS (enter), then touch
the display to confi rm
5. Use the right arrow keys to select: COVER CALIBRATION START
6. Follow the instructions on the LINKTouch* for calibration or correction.
When calibration or correction succeeded, the status LED will become
green
During calibration, the ‘open’ and ‘close’ position of the DURACOVER Cover
System are saved in the memory of the DLC-010. After this calibration, the
user can open and close the cover safely without crossing the end positions.
Settings
menu
* Also see LinkTouch manual
ON
1 2 3
DIP switch 1 to ON:
Remote control (via LinkTouch)
is activated
Dead Man Switch settings
Go to the COVER SETTINGS menu (see above)
In the DMS MODE menu, you can choose the right DMS setting for you:
- enabled
(DMS is active when opening AND closing the cover)
- disabled
(DMS is OFF)
- open only
(DMS is active only when OPENING the cover)
- close only
(DMS is active only when CLOSING the cover)
