11
10
Calibration
During calibration, the ‘open’ and ‘close’ position of the DuraCover System
are saved in the memory of the DLC-010. After this calibration, the user can
open and close the cover safely without crossing the end positions.
OFF
ON
Step 1: Bring cover to the OPEN position
1. Set slide switch CALIBRATION: OFF
2. Set slide switch FORCE: ON
3. Use the keyswitch to move the cover
to the desired OPEN position
ON
OFF
Step 2: Bring cover to the CLOSED position
1. Set slide switch CALIBRATION: ON
2. Set slide switch FORCE: OFF
3. Use the keyswitch to move the cover
to the desired CLOSED position
OFF
OFF
Step 3: Save
1. Set slide switch CALIBRATION: OFF
2. Set slide switch FORCE: OFF
3. When the calibration is succesfull, the
status LED will become green
Correction
During correction, the ‘open’ and ‘close’ position can be updated without
restarting the full calibration process. This function is only possible if a cali-
bration was already done before
When the ‘open’ position is corrected, the ‘close’ position is changed accord-
ingly (and the other way around).
Procedure:
1. Set the FORCE slide switch to ON, in case the cover needs to move
beyond the current calibration limits. (Calibration slide switch can stay
OFF)
2. Use the keyswitch to move the cover to the correct OPEN or CLOSED
position.
3. Set slide switch CALIBRATION: ON
4. Set slide switch CALIBRATION: OFF
5. When the calibration correction succeeded, the status LED will become
green.
Dead Man Switch settings
DIP switch 2 & 3 can be used to activate Dead Man Switch mode (DMS*):
*Dead man switch (DMS) mode is a working mode that requires the user to keep controlling the
open or close switch while operating the cover. When the control is released, the cover move-
ment stops immediately.
ON
1 2 3
Flip the desired DIP switch to the ON position, to activate the designated DMS
mode.
DIP switch 2: DMS to OPEN cover
DIP switch 3: DMS to CLOSE cover
