DuraTech Industries HAYBUSTER CMF-710, Operating Instructions Manual

Page: 23 / 150

11
C M F - 7 1 0 O P E R A T I N G I N S T R U C T I O N S
•
Do not exceed load capacity of the CMF‑710. (See loading instructions in Section 3.7)
•
Do not clean, lubricate or adjust your CMF‑710 while it is moving.
•
Periodically clean the equipment to prevent buildup of dry combustible materials.
•
Be especially observant of the operating area and terrain – watch for holes, rocks other hidden hazards.
Always inspect the area prior to operation.
•
Be extra careful when working on inclines.
•
Pick the most level route possible when transporting across fields. Avoid the edges of ditches or gullies
and steep hillsides.
•
Never leave the CMF‑710 running unattended.
•
As a precaution, always check the hardware on the CMF‑710 following every 100 hours of operation.
Correct all problems. Follow the maintenance safety procedures.
DURING SERVICE & MAINTENANCE
•
Before working on or near the CMF‑710 for any reason, including servicing, cleaning, unplugging or
inspecting machine, use normal shut down procedures unless instructed differently in this manual.
•
Never work on or near the CMF‑710 unless engine is shut off, and all power drives and PTO are
disengaged. Always follow normal shutdown procedures.
•
Check periodically and tighten any loose bolts or connections.
•
Where replacement parts are necessary for periodic maintenance and servicing, genuine factory
replacement parts must be used to restore your equipment to original specifications. DuraTech Industries
will not claim responsibility for use of unapproved parts and/or accessories and other damages as a result
of their use. If equipment has been altered in any way from its original design, DuraTech Industries does
not accept any liability for injury or warranty.
•
If it is necessary to operate the tractor engine indoors for more than a few seconds, be sure to provide
enough ventilation to remove the tractor exhaust fumes.
•
Hydraulic fluid escaping under pressure can be invisible and have enough force to penetrate the skin.
When searching for a suspected leak, use a piece of wood or cardboard rather than your hands. If injured,
seek medical attention immediately to prevent serious infection.
•
Relieve all pressure in the hydraulic system before disconnecting the hose or performing other work
on the system. Make sure all connections are tight and the hose is in good condition before applying
pressure to the system.
•
Replace all shields and guards after servicing and before moving.
DO NOT PERFORM MAINTENANCE ON THE INTERIOR OF THE TUB DURING
WET WEATHER CONDITIONS