DuraTech Industries HAYBUSTER CMF-700, Operating Instructions And Parts Reference

Page: 33 / 233

19
C M F - 7 0 0 O P E R A T I N G I N S T R U C T I O N S
3.2.8 Free motion automatic clutch
Torque protection is built into the PTO driveline with two
free motion automatic clutches. These clutches are located
on each driveline immediately before each gearbox.
When overload occurs the clutch disengages and does not
reengage until the driveline speed is reduced to near zero.
The clutch makes a loud click when it disengages.
3.2.9 Scale Indicator
The indicator for the four‑point scale should be mounted on the indicator mount located on top of the main conveyor.
The mount can be mounted in the left or right side of the conveyor. The indicator is powered by a 12 volt battery
located under the tub on the left side of the frame.
SEE OPERATOR’S MANUAL FOR THE DIGISTAR
EZ-2000 SCALE INDICATOR FOR OPERATING INSTRUCTIONS.
3.2.10 Two-Speed Gearbox (Option)
The two‑speed gearbox is available on the CMF‑700 for operators who want more control of their mixing speeds,
want to reduce overall horsepower requirements, or prefer to turn off mixer while transporting a loaded mixer. The
two‑speed gearbox has two speeds, low and high. Pictures in Section 6.5, show lever in two positions in both gear
selections.
3.2.11 Extension Conveyor Spouts (Option)
Spouts are available with or without magnets. Spouts are adjustable in three hole positions on sides. Point spout down
further when running the conveyor extensions at higher angles to avoid material build up on the end of the conveyor.
When running conveyor at lower angles, direct spouts so that the magnets are positioned further into the flow of
material. Pictures of available spouts can be found in Sections 6.2 and 6.3 .
figure 3.5
EZ-2000 scale indicator
scale indicator