43
1 1 5 0 / 1 1 5 5 H A Y B U S T E R T U B G R I N D E R O P E R A T I N G I N S T R U C T I O N S
3.25 Removing the 1150/1155 HAYBUSTER TUB GRINDER from storage
To remove the 1150/1155 HAYBUSTER TUB GRINDER from storage, perform the following steps:
1. Perform a thorough pre‑operation inspection as specified in Section 3.1 (page 26) of this manual.
To install a screen, perform the following steps:
1. Raise the tub completely, and install the hydraulic cylinder lock.
2. Unlatch the screen hold-downs.
3. Screens may be lifted from or placed in the machine with a hoist or lifting device.
4. Securely attach the screen to the lifting device with a sturdy chain or nylon sling. Stuck screens can
require a force many times their weight to lift them free of the grinder.
5. Use only pry bars to guide the screens in and out of
the machine. The screens are very heavy and could
easily cause injury if the screen moves suddenly or
is inadvertently dropped.
6. Clear all material from the screen track before
installing a new screen.
7. Install the new screen using the lifting device and
pry bars as explained above.
8. Make certain that the screen fits completely in
place, and latch the screen hold-downs.
9. Make sure all personnel and equipment are clear of
the tub platform.
10. Remove the hydraulic cylinder lock, and lower the
tub.
3.26 Installing a screen
CAUTION:
Follow normal shutdown procedure after tilting the tub and prior to performing any
service work in the rotor area.
CAUTION:
Disengage the fluid coupler, shut off the engine, remove the key, and wait until the
rotor has stopped spinning before entering the tub.
installed screen
screen hold-down