DURAG D-R 290, Operating Manual

Page: 117 / 202

6 | Commissioning
D-R 290 117
Key word Range Component see section
3 Measured value out­
put separately in each
case for channels 1…
4
Variables
setting
Type code
Limit values
Measured value correction
Integration time
Signal range
Output the control cycle
(settings)
Zero range
7.5 Example: Setting variables
for the measurement channels
(channel #1)… (channel #4)
[
}
125] and the following
section
4 Analogue output and
relay settings
Analogue output
and
relay settings
Analogue output settings
●
Channel for analogue
output
●
analogue output range**
Relay settings
●
Relay 1
●
Relay 2
●
Relay logic
7.6 Example: Assignment of the
device outputs [
}
134]
5 Maintenance
settings*
Maintenance
settings
Reference point test setpoint
(Duration of the control
cycle step
Control cycle interval
Fault indication suppression)
7.7 Maintenance setup [
}
139]
6 Test and simulation
functions
Functions Simulation of the analogue
output fixed value, simula­
tion of the measurement
channels, simulation of the
digital outputs
Table 6.2: Checklist for parameter checking (general)
Other entries are device-specific:
Key word Range Component see section
7 Device configuration Device-specific
settings
Device variant,
fail-safe shutter fitted
Device configuration
8 Measured values Device-specific
settings
Contamination, zero point
value, reference point value
7.7.5 Measured values [
}
142]
9 Settings Device-specific
settings
Data for gravimetric calibra­
tion, stack correction factor,
measurement path length
7.7.6 Settings [
}
142]
10 Device status Device-specific
settings
Device status, device tem­
peratures, purge air flow,
fail-safe shutter position
7.7.7 Device status: [
}
143]
11 Maintenance and
service functions
Functions Control cycle, contamination
check, zero point check and
reference point check
8.2.10 Control cycle [
}
162] ,
8.2.8 Contamination check
[
}
161] , 8.2.7 Zero point check
[
}
161] , 8.2.9 Reference point
check [
}
162]
12 D-R 290 Checking the
linearity
Functions Checking the linearity 8.2.6 Checking the linearity
[
}
158]