Duracraft AMD-67E, User Instructions

Page: 8 / 78

7
ENGLISH
Measurement
1. Plug the appliance in.
2. Empty the water tank.
3. Put the water tank in place.
The appliance will automatically switch on after the
set time.
1. The appliance will start working when the tempe-
rature is above 16 °C.
2. Defrost the evaporator; the compressor will then
start working
Defrost the evaporater; the compressor will then
start working.
Clean the air filter.
Place the appliance on a level, dry surface.
Reason
1. The plug is not plugged in.
2. The water tank is full.
3. The water tank is not in place.
The timer has been programmed.
1. The room temperature is below 16 °C.
2. There is frost on the evaporator (based under the
air filter).
There is frost on the evaporator (based under the
air filter).
The air filter is dirty.
The appliance is uneven.
TROUBLE SHOOTING
Trouble
The appliance is switched on by the "On/Off”-button
but it does not work
The indicator shows an operating mode but the
appliance does not work.
The "cooling” mode has been selected but the appli-
ance does not cool.
The "dehumidifying” mode has been selected but
the appliance does not blow cool air.
The air volume is too little.
The noise level is very loud and the appliance vibra-
tes.
CONDITION OF PURCHASE
As condition of purchase the purchaser assumes responsibility for the correct use
and care of this KAZ product according to these user instructions. The purchaser
or user must himself or herself decide when and for how long this KAZ product is
in use.
WARNING: IF PROBLEMS ARISE WITH THIS KAZ PRODUCT, PLEASE OBSERVE
THE INSTRUCTIONS IN THE GUARANTEE CONDITIONS. DO NOT ATTEMPT TO
OPEN OR REPAIR THE KAZ PRODUCT YOURSELF, AS THIS COULD LEAD TO
TERMINATION OF THE GUARANTEE AND CAUSE DAMAGE TO PERSONS AND
PROPERTY.
Technical modifications reserved.