4. Refer to your Wall Layout Diagram to identify the Side Panels for the Front Corner. Align
the
fi
rst panel with the chalk line on the deck. Then slide it toward the Front Corner until it
hits the awning.
Then measure distance ‘A (see Drawing) from bottom of the vertical ‘U Channel of the
Front Wall Panel to the front edge of the Wall Panel.
6. Two Solid Spacer Panels, about six inches wide,
are provided to be installed between both second
Side Wall (or Door) Panels and the RV.
Also provided is a 12” piece of ‘U Channel and a 12” piece of Gable Wall Joiner.
Measure the opening for the Spacer Panel from the back of the Side Wall Channel to back of
RV Wall Channel. Make the measurement at both the top and bottom of the opening so the
panel can be cut to compensate for the RV being out of plumb.
Measure from the Deck to top of Wall Panel (not the Gable Wall Joiner) for proper Spacer
Panel height. Cut Spacer Panel to
fi
t these measurements.
7. Remove second Screen Panel.
8. Cut a section of ‘U Channel to
fi
t bottom of Spacer Panel
and slide onto the Panel. Then cut a 1” notch in each end of
the 12” piece of Gable Wall Joiner as shown in drawing. Cut
piece of Gable Wall Joiner to
fi
t the top of the Spacer Panel
and slide it on the Panel with the Notch toward the Wall
Channel. Now slide Spacer Panel into the RV Wall Channel.
9. Replace the second Screen Panel. Replace the Trim Cover.
Mark that same distance ‘A back from edge of Wall
Panel. From that mark just made extend it to top
of Gable Wall Joiner. Draw diagonal line as shown
and cut off triangular piece. Now you can slide Wall
Panel into Corner Channel.
5. Continue by positioning the second Side Wall Panel
indicated on Wall Layout Diagram. Temporarily set a
Trim Cover in position on the Wall Panels. Hold Trim
Cover in place with a clamp at the top.
Page 4
