Preparing and Installing Gable Panels
1. The 24” x 96” panel received with your Dura-Breeze Screen Room must be cut into two
pieces to match your roof pitch.
Before proceeding, make sure roof is
fi
rmly seated on the front Wall Panels.
2. Start the layout for cutting the Panel by getting
measurement “A” (See Drawing) which is along the top of
the Wall Panels from back of RV Wall Channel to the front
end of the Side Wall Panels. Measurement “B” is the
RV Wall Channel; from top of Wall Panel to top of the RV
Channel. Measurement “C” is 1/2” up the side of
Panel from the edge of “A”. “D” is line drawn between “B”
and “C”. Cut Panel on line “D”.
10. Install Center Post inside the room. Center Post on
the joint of the two screen panels. Loosen Black Knob and
adjust the post insert up into position and then tighten
Black Knob to hold into position. Plumb post and then mark
position of Post Top on the underside of Awning. Lower
post insert and tighten knob to prevent insert from sliding
down inside post. Remove Post Top Bracket and fasten in
position just marked. Fasten with #8 x 1/2” screw through
center of Post Top Bracket. Slide Post back up into
position and install screw and wing nut. Be sure wing nut
is on inside of room. Recheck to be sure post is plumb.
12. Attach Trim Cover by
fi
rst drilling through
pre-punched center and bottom holes and then
install Bolts and Wing Nuts as in the other
Trim Cover installations.
13. Install the provided 3” long Anchor Angle
as you did at the front corners. It should be
located at the joint of the Wall Panel and the
Spacer Panel.
14. Repeat process for other side wall.
11. Secure bottom Post Anchor with screws supplied. When the post has been installed
correctly it will leave a 1-1/4” space between head of the screw on Post Top Bracket and
Valance Track. The 1-1/4” is clearance needed for Gable Panel.
Page 5
Note: If You are installing Posts on a Pressure Treated Lumber Deck.
You will be supplied with a piece of 4” x 4-1/2” Black Flashing with
Paper coated adhesive on one side for each Post. Peel the paper off
from the Flashing and stick the Flashing to the bottom of the Post
Anchor. Then trim the excess Flashing from around the Post Anchor.
Black Flashing
under Angle.
v
