All dimensions are approximate and subject to the limitations of the material used and the methods of manufacture
Roof insulation (optional extra)
IMPORTANT - Roof insulation should be installed prior to felt
or shingles
Please refer to the diagram (left) to find out how to orientate
and cut the insulation panels.
After the roof boards have been attached, start from one side of
the cabin placing the insulation panels on top of the roof boards
and square to the edges, lay the panels with the insulation facing
down and the particle board on top; insulation panels may require
cutting on site to the right dimensions.
Screw the 35mm thick insulation panels down to the roof boards
using 50mm screws. Fix screws around the edge of the panel
at approximately 450-500mm apart.
IMPORTANT - screws are only 4mm shorter than the combined thickness
of the insulation and roof boards so do not over tighten.
Please note that roof edge reinforcement trims and eave edging trims
are supplied in different lengths which require cutting on site:
Fit the roof edge reinforcement trims (J.1960) to the underside
of the roof boards screw up into the roof boards, using 35mm screws
Fix the eaves edging (HN.2000 / HN.3000) using the provided
L-brackets. To do this, screw the brackets onto the back,
flush with the top of these trims at approx. 1m intervals
using 20mm screws, and then fix the other side of the bracket
onto the top of the roof insulation.
Rear Elevation
Front Elevation
3x50mm Screws for roof insulation
3x20mm Screws for metal brackets
Metal brackets
140x
60x
14x
4x
Panel A
3x
Panel K
Panel A
Panel A
Panel A
(required to be cut on site)
Panel A
(required to be cut on site)
P
a
n
e
l
A
(o
ff
c
u
t)
P
a
n
e
l
K
P
a
n
e
l
K
P
a
n
e
l
K
(r
e
q
u
ir
e
d
t
o
b
e
c
u
t
o
n
s
it
e
)
P
a
n
e
l
K
(o
ff
c
u
t)
1250
350
350
1250
2
5
0
0
1
8
1
5
4
3
1
5
1600
1600
