21
Installation and Operation of
Product Holding Cabinets
Power Up
1. Place the Power Switch in the ON position. Software
initializes at startup.
2. Until warmer reaches preprogrammed operating
temperature, all displays will show actual temperature.
3. When the set point is reached, Product Name
appears on all Pan Displays.
Note:
For these instructions only the pertinent keypads
will be shown, for simplicity, and not the warmer or
pans. It is implied that a product pan is located above
and below each keypad.
Timer Operation
1. Press Arrow Button that corresponds to pan the
product is in. (In this example, there is product in
pan above keypad).
2. Status LED turns GREEN (unless same product
present in another pan, then Status LED will remain
non-illuminated) and Pan Display alternately shows
Time Remaining and Product Name.
3. At t=cook time (set to 4 minutes) the Status
LED begins FLASHING, alarm sounds and
Display alternately flashes Time Remaining
and Product Name.
4. Push Arrow Button to silence alarm – Status LED
remains GREEN and stops flashing.
5. At t=0, alarm sounds, Status LED is FLASHING
and “00:00” is FLASHING in the Display.
Discard
product in pan
. Press corresponding Arrow Button
to silence alarm and reset timer.
6. Status LED becomes non-illuminated and Display
shows Product Name only. The pan is ready for
more product.
Note:
To reset the time when product is depleted, press
and release the corresponding arrow key. The status
LED will become non-illuminated any status LED on
the same product will turn green, indicating use first.
Summary of Contents for FWM 6-42 SERIES
Page 2: ...Installation and Operation of Product Holding Cabinets 2...
Page 40: ...Installation and Operation of Product Holding Cabinets 40 FWM34 4 High Schematic...
Page 42: ...Installation and Operation of Product Holding Cabinets 42...
Page 43: ...43 Installation and Operation of Product Holding Cabinets...
