Installation and Operation of Flexible Batch Broiler – Electric
8
D. ADJUSTMENTS AT INSTALLATION
Each broiler section and all its component parts have
been tested thoroughly and inspected before your broiler
was shipped from the factory. However, it is sometimes
necessary to further test or adjust the broiler once it has
been installed. Such adjustments are the responsibility
of the Dealer or Installer. These types of adjustments
are not considered defects, rather a normal and routine
part of the proper installation of the equipment.
These adjustments include but are not limited to:
• Broiler height adjustment (if required)
No installation should be considered complete without
proper inspection and, if necessary, any adjustments
by qualified service or installation personnel.
It is also important not to obstruct the natural flow
of ventilation air if the broiler is to operate properly.
This broiler should not be installed on a curb base or
sealed to the wall. Either condition can prevent proper
ventilation of the unit.
Before making any connections to the broiler, check the
ratings plate to be sure the broiler specifications concur
with the voltage to be supplied to the broiler.
The rating plate is located on the back of the lower control
compartment cover panel on the right end of the unit.
The plate bearing the broiler’s model number and serial
number is attached to the back side of the unit.
Raise or Lower Broiler
The broiler height can be adjusted via two screws on
each leg.
Caution: The Broiler is very heavy! Use adequate
help for lifting.
1. Lift one end of the broiler onto a wide, sturdy stand
(not supplied).
2. Remove (2) screws per leg and raise/lower to
threaded holes. Reinstall screws.
3. Remove stand and safely raise/lower broiler.
4. Place plastic hole plugs (supplied attach to stand)
in any unused holes.
Support
broiler here
Screw
Slide Leg.
Reinstall screws.
Plastic Hole Plug
