182
8
. Appendix
Indicator Message
(Error message)
POWER
STATUS
LAMP
TEMP.
Projector status
Procedure
A button has been pressed while the
KEY LOCK is activated.
The projector's keys are locked. The
setting must be canceled to operate the
projector. (
→
page
Blink
Orange
(
Light
)
Status
varies
Off
ID numbers for the projector and the
remote control do not match.
Check the control IDs (
→
Lamp replacement grace period.
The lamp has reached the end of its ser-
vice life and is now in the replacement
grace period (100 hours). Replace the
lamp
to new one
as soon as possible.
(
→
)
Status
varies
Off
Orange
(
Blink
*
5
)
Off
Lamp replacement time exceeded.
The lamp has exceeded its replacement
time. Replace the lamp immediately.
Status
varies
Off
Red
(Blink*
5
)
Off
Preparing to relight lamp after lighting
has failed.
Wait a while.
Blue
(Blink*
5
)
Off
Green
(
Blink
*
5
)
Off
Temperature problem (In the Forced
ECO)
Ambient temteprature is high. Lower the
room temperature.
Blue
(
Light
)
Off
Orange
(
Light
)
Orange
(
Light
)
Temperature problem
Ambient temperature is
out of the
operation
temperature. Check if any
obstruction stays near the exhaust vent.
Red
(
Blink
*
5
)
Off
Off
Off
Lamp does not light.
Wait
at least 1 minute, them turn on the
power back on.
if
the lamp still does
not light, contact your delaer or service
personnel.
Red
(
Blink
*
5
)
Green
(
Light
)
Red
(
Light
)
Off
Lens calibration error. (Calibration
error message is indicated on the
display)
Perform lens calibration.
Red
(
Blink
*
5
)
Red
(
Light
)
Off
Off
Lamp cover/Lens problem
Lamp cover and/or lens are/is not
mounted properly. Mout them/it (
→
see
,
Red
(
Blink
*
5
)
Red
(
Light
)
Green
(
Light
)
Off
Error requiring service support
Contact your dealer or service person-
nel. Make sure to check and inform
indicator status for asking to repair.
Red
(
Light
)
Status
varies
Status
varies
Off
*1 Repetition to light on for 1.5 seconds / off for 1.5 seconds
*2 Repetition to light on for 1.5 seconds / off for 7.5 seconds
*3 Repetition to light on for 2.5 seconds / off for 0.5 seconds
*4 Repetition to light on for 0.5 seconds / off for 0.5 seconds / on for 0.5 seconds / off for 2.5 seconds
*5 Repetition to light on for 0.5 seconds / off for 0.5 seconds
•
When the thermal protector is activated:
When inside temperature of the projector becomes too high or low, the POWER indicator start to red blink in a
short cycle. After this happened, the thermal protector will activate and the projector may be turned off.
In this case, please take the below measures:
-
Pull out the power plug from the wall inlet.
-
Place the projector in cool place if it has been placed in high ambient temperature.
-
Clean the exhaust vent if dust has accumulated on.
-
Leave the projector for about one hour until inside temperature gets lower.
