Duevi CE818, User Manual

Page: 18 / 28

18
PARTIAL 1 ARMING
By factory setting, the user 1 code is enabled as MASTER type and code “100000”
To arm the system in
PARTIAL 1 :
With User Code With Electronic Key
1. Press the “ F2 ” button 1. Pass twice a CHT key over a key reader
2. Digit the User Code (factory: “100000”) To arm, it is also possible to hold the key over the key reader
until the GREEN LED lights on (corresponding to the Partial 1
arming) then remove it.
3. A “beep” confirms arming, the GREEN LED on key reader
and “ F2 ” button on keyboard switch on
2. A “beep” confirms arming, the GREEN LED on key reader
and “ F2 ” button on keyboard switch on
4. A “beep” series for about 30 seconds (exit time) are
emitted, after that the system is active
3. A “beep” series for about 30 seconds (exit time) are
emitted, after that the system is active
PARTIAL 1 arming

Active zones *
All the zones enabled in Partial 1 mode but bypassed zones
by the user (User menu – only if Master)
Factory:
Enabled only zones 1 ÷ 5, zones 6 ÷ 8 are disabled
The zone 1 has Delay (Entry time = 30 seconds)
Sound alerts
One “beep” to confirm arming
A “beep” series during Exit time (30 s)
Visual alerts
Key reader: GREEN LED, solid on
Keyboard:
F2 button solid on
Control p. outputs *
Output 1 (“+INS”) changes status
Output 2 (“TC”) changes status
GSM alerts ** SMS for “Partial 1 arming” to enabled numbers
* It is possible to change the settings by Installer menu or software
** If GSM module installed
2x