STP Lite User Manual Revision 1.02
32
Logic Flow Lite
Command
Function
Write Logic to Device
Writes the list of commands to the STP. When you
click on Flash, an indicator bar at the bottom of the
opening screen shows the progress of writing to the
STP. A screen will pop up telling you that the write
was successful, or that it failed
Read Inputs
Updates the user to the state of the digital input and
relay output (result displayed on main screen)
Configurations
Allows you to set the device's:
UNIT ID- is the identification of the controller
maximum character 10
Access Point Name (APN)(for the cellular
service providers that require it) maximum
18 characters
User name that was configured in the SIM
CARD. maximum 18 characters
Password that was configured in the SIM
CARD. maximum 18 characters
To set the number of seconds to delay
sending an outgoing call (10-30 sec)
PIN code of the SIM CARD. maximum 10
numbers
TCP timeout between 10-86400(sec)
To enable/disable output events
To enable/disable input/output change
report to LogicFlow
STP Lite Logic Flow Lite Indicators
At the bottom of the
Logic Flow Lite
screen, you will see the following
indicators:
COM1/9600
: An indication of the serial port and the baud rate.
Verifying that there is communication with the STP Lite
When you first execute the
Logic Flow Lite
software, you will receive
notification that the serial port is not connected to the
STP Lite
.
