8
INSTALLATION
4) FIXING THE COOKTOP
The cooktop has a special seal which prevents
liquid from getting into the cabinet. Strictly comply
with the following instructions in order to correctly
apply this seal:
- Take off all the movable parts of the hob.
- Cut the seal in 4 parts of the necessary lenght to
positionning it on the 4 edges of the glass.
- Overturn the cooktop and correctly position seal
“E” (fig. 10) under the edge of the cooktop itself,
so that the outer side of the seal perfectly
matches the outer edge of the cooktop. The ends
of the strips must fit together without overlapping.
- Evenly and securely fix the seal to the cooktop,
pressing into place with the fingers and remove
the strip of protective paper from the seal and set
the plate into the hole made in the cabinet.
- Position the hob in the hole in the unit and fasten it in
place using the appropriate screws “F” and the
fastening hooks “G” (fig. 11).
- When the appliance is installed so that the base
can be touched, we recommend fitting a protecting
shield. This shield must be at least
70 mm below the base of the bench top (fig. 8).
Timber or other suitable material may be used
provided it is capable of withstanding the appliance
temperatures. Ensure that the supply connection
point is accessible with the appliance installed. To
facilitate the shield may need to be removable.
NOTE: do not fix the cooktop into the bench with
sealant (ie silicon) as this may void the warranty.
Use only the seals provided.
FIG. 10
FIG. 11
FIG. 10/A
Caution: Do not allow the glass (A)
lay directly on the work top. it is the
bottomshelf (B) that has to be in
touch with the work top (see
fig. 10/A).
