Ducati Superbike 848evo Corse, Owner'S Manual, Page: 42 / 144

41
DDA data acquisition
This function activates the DDA analyser (not fitted
for this model, but available at Ducati selling
network): the data logger must be connected to
vehicle wiring. To enable this function, enter the
menu and set “DDA“ data logger to “On“ by holding
switch (12, fig. 6) pressed in position B “
▼
“ for 3
seconds. The START/STOP control for the data
logger lap separator is the high-beam flasher button
FLASH (12, fig. 6) on the LH switch. If the DDA
function is active and the display is suddenly
switched off (Key-Off), the function is switched off
automatically.
Note
Online assistance is available to Ducati Data
Analyser (DDA) owners (http://dda.prosa.com). This
service will provide anything necessary to correctly
use the DDA with your PC: both for the device and
the software for analysing the recorded data.
Warning
After use, disconnect the DDA from the main
wiring harness.
fig. 24