![background image](http://html1.mh-extra.com/html/ducati/multistrada-1200-2016/multistrada-1200-2016_owners-manual_2537705118.webp)
When SET button (7, Fig. 58) is pressed, current
speed is set as target cruise speed.
To confirm correct setting of cruise speed, the target
speed is activated on the instrument panel for 5
seconds.
It is possible to increase or decrease set cruise
speed, by pressing buttons (6, Fig. 58) and
(7, Fig. 58)respectively.
Every "click" corresponds to a speed increase or
decrease of 1 Km/h.
The new set target speed is displayed in the coolant
temperature box when system is reaching said
speed.
When the new requested target speed has been
reached for over 5 seconds the display will show the
coolant temperature again.
Press RES button (6) to resume previous SET speed,
in case the Ducati Cruise Control was previously
disabled.
Important
In case of a long DTC (Traction Control) event,
the Cruise Control will automatically turn off.
Once the system is enabled, it is possible to set the
current speed as the desired speed by pressing RES
(6, Fig. 58) or SET (7, Fig. 58): press RES (6, Fig. 58)
if no target speed has been previously set.
In this case, the system saves the vehicle current
speed and keeps it without the rider having to work
on the twistgrip: the set speed is displayed on the
instrument panel.
In stand-by mode, if you press RES (6, Fig. 58) and a
target speed has been previously set and the
operating conditions are met, the system starts
working again and brings the vehicle to the last set
target speed.
It is possible to enable the Ducati Cruise Control only
if the below conditions are met:
-
second gear or higher engaged;
-
vehicle speed higher than or equal to 50 Km/h (30
mph) or lower than or equal to 200 Km/h (125
mph);
-
the brake has been applied at least once (no
matter if at the front or the rear side) after the
key-ON.
The Ducati Cruise Control can be disabled as follows:
-
turning the throttle twistgrip in the direction as to
decelerate;
117
Summary of Contents for Multistrada 1200 2016
