background image

Dynatek • 164 S.  Valencia St. Glendora CA 91741

www.dynaonline.com   

800.928.3962

User Manual

Parts List

FI Controller
Installation Guide
Wire tap
Wire ties
Velcro

®

Strip

Alcohol Swab

1999-2001 Harley-Davidson 

Twin Cam 88 Touring Models

Part Number DFCH-2

2801187

REV. 6-30-05

Congratulations on your purchase of this Dynatek product. 

Please take a moment to read these instructions completely before

installing the FI controller. The installation will only take a few minutes,

but proper setup for your specific bike will take longer

Summary of Contents for DFCH-2

Page 1: ...ip Alcohol Swab 1999 2001 Harley Davidson Twin Cam 88 Touring Models Part Number DFCH 2 2801187 REV 6 30 05 Congratulations on your purchase of this Dynatek product Please take a moment to read these instructions completely before installing the FI controller The installation will only take a few minutes but proper setup for your specific bike will take longer ...

Page 2: ... 2 pairs of injector connectors Plug the pair with the orange wires into the front cylinder injector harness and front cylinder injector Repeat this using the other connector pair and the rear cylinder injector Locate the TPS connector behind the throttle body STEP 1 STEP 3 STEP 2 Installation Part DFCH 2 2 Rear Cylinder Injector Front Cylinder Injector TPS Connector STEP 3 STEP 2 STEP 1 ...

Page 3: ...when you reinstall the tank Use one of the wire ties to tie the wires to the frame away from the cylinder head Place the FI Controller where you plan on mounting it permanently In most cases this will be under the seat Connect the ground lug black wire to a grounding point on the bike Use the Velcro tape to mount the FI Controller in position Use alcohol swab to clean mounting surface prior to att...

Page 4: ...subtract fuel turn the potentiometer counterclockwise With the potentiometer pointed straight up at the thick tick mark towards the Dynatek logo that is 0 adjustment Fully counterclockwise is 20 and fully clockwise is 20 Adjusting the potentiometer between these points will result in adding or subtracting an amount of fuel proportional to how far the knob was moved from zero Calibration To select ...

Reviews: