Page 14
Close the garage door.
The fixing plate 809 is supplyed pre-assembled to the trolley by 2 brakets. These brackets are supplied
for installation on a
STANDARD NON PROJECTING-UP-AND-OVER DOOR
1°) Push left the unloking handle to release and manually moove the trolley ( draw.28)
2°) Slide the trolley to the front and advance the brackets to find the right fixing position of the plate 809.
3°) If necessary, adjust the leght of the brackets, by sliding them one on another and fix the appropria-
tes holes.
4° )Fasten the plate 809 to the door by means of 2 bolts (not supplied) of the right size and type accor-
dingly to your door. (draw.30)
Warning: the fastening area must be reinforced and structurally resistant.
7° step:
Door fixing
Draw.30
door fixing
plate 809
standard door
brakets
door fixing
plate 809
Draw.32/A
WARNING : for installation on a sectional door,
For the installation on a sectional door, 1 of the 2 supplied standard brackets must be replaced by the
supplied sectional door shaft #992014 as in draw. 32/A
( see also page 6 point 3.2)
Draw29
Draw31
Draw28
unlocking handle
slide the trolley to the front
standard
door braket
sectional door shaft #992014
Use 1 standard door
the sectional door shaft to
connect the trolley to the door.
trolley
