Page 13
Hang the motor head.
The hanging brackets must be attached to the motor plate and angled at 90° at the ends, as is showed
in draw 25-27. Then fasten the brackets to the ceiling.
The rail can be fastened to the ceiling through the holes in the rail braces, in order to prevent the rail
from warping. This is a useful solution expecially when utilising accessory 992012 (up-and-over doors).
6° step:
Motor Head Mount:
Draw.24
Position the pilot holes horizontally on the vertical centre line of the door.
Fasten the bracket 828 to the door jamb or wall by means of 2 bolts (not supplied) of the right size
and type of the structure.
Take and hold the opener to a horizontal position, until it can be attached to the ceiling. (draw.24).
Warning:
the fastening area must be reinforced and structurally resistant.
5° step:
Door Jamb Mount:
6. Fixing instructions
Draw.22
Draw.23
Draw.25
Draw.26
Draw.27
Bracket
828
belt tightener
Bolt
rail
