5
NOTE:
Some of th
e heater’s functions can only be accessed using the remote included with
the heater.
Switching ON (Master Switch)
Once the heater has been mounted on the wall and correctly connected to the main
electricity power supply, press the master On-Off switch at the back of the heater on the
right hand side.
With the switch in the On position, the flush part will be at the top of the switch.
NOTE:
If the power is interrupted for any reason, when the power is restored the heater will
be in standby and the clock will be reset and all selected functions will default to off. Your
temperature and program will be retained.
Setting the time
Before operating the heater you must set the date and time.
To do this press
the “LOCK” button on the remote control until the LED display shows 00:00
and the
“Mo” icon. Then follow the steps below:
1.
Press the “Set” button and the “Mo” icon will begin to flash.
Use the + or - button to scroll through to the correct day. (Mo=Monday...Su=Sunday
etc.
) then press “Set”
2. The hour part of the time will start to flash.
Using the + or
– button set the current hour and then press “Set”
3. The minute part of the time will start to flash.
Using the + or
– button set the current minutes and then press “Set”
NOTE:
Once the “Set” button has been pressed, you have 5 seconds to input your choice
and press “Set” to move to the next option, otherwise the heater will return to standby.
If the heater is switched off at the mains, the day and time will be lost.
5. OPERATING INSTRUCTIONS
6. INITIAL SETUP
