background image

10 

 

This  heater  is  protected  with  an  overheat  protection  failsafe  that  switches  the  heater  off 

automatically if it senses that it is about to overheat. 

An example of this would be due to total or partial obstruction of the inlet vents. 

In this scenario, disconnect the mains power to the heater and wait 30 seconds for it to cool 

down. Once the heater has cooled down, remove any obstruction from the inlet vents.   

Switch it back on as described earlier in the manual.   

After  the  heater  has  been  switched  on,  the  heater  will  operate  normally.  If  the  problem 

persists, please contact your supplier for assistance. 

Before undertaking any cleaning or maintenance on the heater, disconnect it from the power 

supply. 

For cleaning it is recommended to use a soft moist rag and neutral detergent. Do not use an 

abrasive cloth or substances which could affect the appearance of the heater. 

Check that the hot air outlet and the inlet vents are free of dust and dirt. 

During cleaning, be careful not to touch the heating elements. 

In case of breakdown and/or poor functioning of the heater, disconnect the heater from the 

power supply and contact your supplier. 

NOTE:

  As  a  result  of  continual  improvements,  the  design  and  specification  of  the  heater 

may differ slightly to the unit illustrated on the packaging. 

Ducasa heaters require very little maintenance. 

The surfaces of the heater must not be cleaned with an abrasive product or those containing 

granular substances. We recommend regular cleaning with PH neutral products. 

In order to clean the heater, it is recommended that the electric power is switched off. 

Your appliance is guaranteed for two years from the date of purchase 

– during this period 

we  will  repair  or  exchange,  at  our  discretion,  any  faulty  or  defective  parts  providing  the 

appliance  has  been  used  in  accordance  with  the  operating  &  installation  instructions  and 

has not been misused or mistreated in any way. 

Any unauthorized repair or attempted repair will invalidate the guarantee. You may be asked 

to return the product to our workshop for inspection to establish whether the fault is covered 

under the guarantee.   

The guarantee is valid in the UK only. 

This guarantee is additional to your statutory rights. 

In the unlikely event of a problem with your appliance please contact your supplier. 

 

16.   OVERHEAT PROTECTION 

17.   CLEANING & MAINTENANCE 

18.   MAINTENANCE AND CARE 

19.   GUARANTEE 

Summary of Contents for M-28 Downflow












Reviews: